Realgna Board
  • Trainer Kit with Two FPAAs (AN231E04) & 32bit PIC microcontroller with 80MHz clock, 512KB flash, 32KB data memory.

  • Standard USB serial interface & 5 pin header for programming / reprogramming Microcontroller.

  • Provision to configure 1 or 2 FPAA chain, store configuration in Flash & also to electrically isolate Analog and Digital section.

  • Board size 190 x 130mm.

  • Supply requirement- single supply +5V to +7V.

  • 16X2 LCD Display mountable

  • Ability to Dynamically reconfigure FPAAs

  • Standard USB serial interface for downloading EDA software

  • SPI bus for configuration and dynamic reconfiguration

  • The trainer kit has onboard components for performing following academic experiments

    • Two audio jacks for performing Audio Signal Processing Experiments.
    • Onboard PPG sensors for monitoring Heart rate
    • 10k Ohm Potentiometer for performing Voltage Controlled Oscillator experiments
    • Three 10K Ohm Potentiometer for providing dynamic data to reconfigure FPAA parameters through PIC microcontroller for algorithmic method of dynamic reconfiguration.
    • Pair of Terminal blocks for Filter Experiments and also set of TBs for performing basic experiments.
    • 1 Number of general purpose IO, 1 number of general purpose input, 3 numbers of general purpose outputs. And all general purpose IOs, Input pins, Output pins accessed through terminal blocks from the board edge for academic experiments
    • Input Rauch filters & Output buffers, for all the experiments.

  • Supplied with all the necessary accessories like USB cable, power card,Audio Cable,Screw Drivers, CD with EDA software.